msp430x20x2_adc10_temp

说明：  中颖单片机SH79F161的基础驱动程序源代码ADC(Ying SCM SH79F161 in driver source code based ADC)

实现智能数字显示仪表。要求8位数码管显示（4位显示测量值，4位显示设定值），4输入按钮（功能选择、数码管选择、数字增加、数字减少），可设定上下限报警（蜂鸣器报警）。K型热电偶（镍铬-镍硅），测温范围为0℃~1000℃。采用比例-积分控制、并用晶闸管脉宽调制驱动1000W电加热器（电源电压为AC220V）。(Intelligent digital display instrument. Asked 8-bit digital display (4 shows measured values, four display settings), 4 input buttons (feature selection, the digital control options, the number increased, the number is reduced), upper and lower limits can be set to alarm (buzzer alarm ). K-type thermocouple (Ni-Cr and Ni- Si), temperature range is 0 ℃ ~ 1000 ℃. Proportional- integral control, and using thyristor PWM drive 1000W electric heater (power supply voltage is AC220V).)

无线网络中节点均匀分布的解码转发机会中继性能分析0479-8023(2012)02-0183-10(Performance Analysis of Opportunistic Relaying with Regenerative Relays in Wireless Networks ?ased on the Randomly Distributed Nodes)

超声波流量计，在proteus上仿真的模拟程序，用tdc-gp2进行的时差法测量(Ultrasonic flowmeter, the proteus simulation simulation program, transit-time measurement conducted tdc-gp2)

用于STM8系列芯片的BQ24295芯片驱动代码，用于控制单节锂电池的充放电管理，使用了“STM8S_StdPeriph_Lib_V2.2.0”库函数用于IO配置，使用了虚拟I2C和虚拟SPI端口控制(code be used to drive bq24295 on stm8, can control one li-on battery charge and discharge, the code based on "STM8S_StdPeriph_Lib_V2.2.0" library(for config the IO), based on virtual spi and i2c.)

单总线温度DS18b20程序，适用于AVR单片机。(Single-bus temperature DS18b20 procedures applicable to the AVR microcontroller.)

old gpio interface to other kernel modules don t use in new code, will go away in 2.7 have a look at bttv-gpio.c instead.

m128的pwm控制，控制呼吸灯，已经编译过了(PWM control of M128)

STM32_PWM利用PWM1来配置输出，可以驱动一个LED灯，实现呼吸灯效果。(STM32_PWM use PWM1 to configure the output can drive an LED light to achieve breathing light effect.)

msp430的ADC的总结，包括通道选择等等(The ADC msp430 summary, including channel selection, etc.)