estimationofsignals

关于神经网络控制，在matlab环境中自动识别连通区域的大小,车牌识别定位程序的部分功能，是信号处理的基础，多目标跟踪的粒子滤波器，本科毕设要求参见标准测试模型。(On neural network control, Automatic identification in the matlab environment the size of the connected area, Part of the license plate recognition locator feature, Is the basis of the signal processing, Multi-target tracking particle filter, Undergraduate complete set requirements refer to the standard test models.)

解决最小费用最大流问题，一般有两条途径。一条途径是先用最大流算法算出最大流，然后根据边费用，检查是否有可能在流量平衡的前提下通过调整边流量，使总费用得以减少？只要有这个可能，就进行这样的调整。调整后，得到一个新的最大流。(Minimum cost maximum flow problem to solve, there are generally two ways. One way is to use a maximum flow algorithm to calculate the maximum flow, then the cost side, check whether it is possible under the premise of the flow balance by adjusting the edge flow, so that the total cost can be reduced? As long as this possible, for such adjustments. Adjusted to obtain a new maximum flow.)

continues analysis of discrete signal, not integer shifting of a discrete signal

一个关于OFDM子载波的分配算法源程序，希望对大家能有所帮助。(Subcarriers on the MATLAB source code distribution algorithm, in the hope that we can help.)

power factor improvement by using converters

模拟数字PID控制器的功能,能简单实现其功能,采用matlab环境来实现.(Analog and digital PID controller function, can be simple to achieve its function, using matlab environment to achieve.)

程序名称:gm1n.m GM(1,N)模型,程序功能:利用GM(1,N)模型进行预测。程序编写:mongvi@126.com。开发指导:刘思峰教授。程序发布:南京航空航天大学灰色系统研究所。(GM gm1n.m (1, N) model。Function: GM (1, N) model is used to forecast. )

利用蚁群算法的改进算法实现图像分割，并与传统蚁群算法作比较(The improved ant colony algorithm is used to realize image segmentation and compared with the traditional ant colony algorithm.)

单载波频域均衡中，信道是一个很关键的问题，信道估计的好坏也直接影响系统的性能，确定一个好的信道估计序列是至关重要的，chu 序列是一种很好的估计序列(Single-carrier frequency domain equalization, the channel is a very critical issue, good or bad channel estimation is also directly affect the performance of the system to determine a good channel estimation sequence is critical, chu sequence is a good estimate of the sequence)

说明：  这是一个GM(1,1)模型的代码，可以直接用的(This is a GM (1,1) model code, can be directly used)