ddddd

利用GPIB接口控制K2306上下电，电压5V。(The control of K2306 electric interface using GPIB, voltage 5V. )

g.722 code for speech compression

MIMO虚拟技术信道容量随信噪比的变化关系图像，MATLAB仿真程序，源代码(Virtual MIMO channel capacity with the signal-to-noise ratio of the change in the relationship between image, MATLAB simulation program, the source code)

说明：  这是一个齿轮设计的软件,设计齿轮的参数全部动算出.(This is a gear design software, design parameters calculated move all the gear.)

Arduino Uno Sketch to take measurements a strain gauge at precise depths into an elastic object. Interfaces the Uno with a micrometer using SPC and with strain gauge bridge circuit using Analog input pin. Tested to work on OSEPP Uno R3 Plus (Arduino Uno equivalent uC)

用C++编写的xu-white模型，适合砂泥岩地层岩石物理建模，很实用(Written by C++ xu-white model, suitable for sand-shale formation rock physics modeling, it is practical)

kk飞控的程序，kk飞控是一款低端的很廉价的很好的飞控程序。适合初学者玩多轴飞行器。(kk flight control procedures, kk flight control is a very cheap low-end good fly control program. Suitable for beginners to play multi-axis aircraft.)

说明：  计算温度场分布的程序，希望对有关人员有所帮助,基于matlab(Calculated temperature distribution of the procedures in the hope the officers concerned be helpful, based on matlab)

Clear Case briefly introduction power point

说明：  该程序可以建立一个链表，然后随机的插入节点(The program can build a linked list, and then randomly insert the node)