FT

1/f Noise Characteristics of Sub-100 nm MOS Transistors

Matlab code to uate H1 and H0 in CR

In Modulation schemes such as OFDM transmitter time domain signal will have higher PAPR, which leads to various distortions in the transmitter chain and degradation of system performance i.e. BER/PER. Also requires highly linear power amplifier which increases cost of the system. PAPR is ratio of peak power to average power of time domain complex baseband signal which is to be transmitted. We will discuss PAPR reduction techniques below.

Frequently used algorithms for numerical analysis and signal processing(Frequently used for numerical algorithms analysis and signal processing)

detecting the Edge from an image with the filter

说明：  铅垂平面比利导引法弹道仿真程序，基于MATLAB编写(Vertical plane guidance law Billy ballistic simulation program, based on the MATLAB prepared)

Power system state estimation for monitoring power flows and voltages on a transmission system.

说明：  现代信号处理功率谱估计部分，通过导频估计(this is the function that estimates the power spectrum)

Routing of packets has been the primary method by which data have been transmitted across packet networks, such as the Internet. When multiple users are interested in the same data the same source, multicast routing is typically used. However, routing alone is not sufficient to achieve the multicast capacity of a network. Ahlswede at [1] showed that using network coding that requires intermediate nodes to encode incoming data a multicast capacity equal to the minimum of the min-cut capacities of all the receivers can be achieved. This multicast capacity cannot be achieved using only routing (with or without replication). There has been a lot work going on to use network coding for multicast in satellite systems.

这个程序是matlab用来来对锁相环（PLL）进行仿真的，这样的选择基于多方面的考虑(This procedure is used Matlab to the phase-locked loop (PLL) simulation, This choice is based on a number of considerations)