comm_tb

求杂波秩的Matlab源代码，特别是针对强杂波的环境下，所以有需要的兄弟可以下载这个参考一下，呵呵 (For clutter rank Matlab source code, especially against strong clutter environment, hence the need for the brothers can download this reference, huh, huh)

这是一个基于matlab的一个pca变换，先从去均值处理，在降维，然后一些列变化(This is a based on the matlab a pca transform, first from to mean processing, on dimensional reduction, and then a few changes )

Cleve Moler的MATLAB教材Numerical Computing with MATLAB和代码，介绍MATLAB数值方法入门，计算技巧的教材。(Numerical Computing with MATLAB is a textbook for an introductory course in numerical methods, Matlab, and technical computing.)

matlab函数“LFM.m”计算和画出LFM波形的幅度谱。(matlab function " LFM.m" calculate and plot the amplitude spectrum of LFM.)

用一维小波变换进行图像去噪处理，有较低的计算复杂度，提高效率和计算速度。(Victoria with a wavelet transform image denoising, lower computational complexity, increase efficiency and speed.)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

包括脚本文件和函数文件形式，DSmT证据推理的组合公式计算函数，使用混沌与分形分析的例程，光纤陀螺输出误差的allan方差分析，旋转机械二维全息谱计算，独立成分分析算法降低原始数据噪声。

pca图像融合原代码，功能能很强大,很实用(nice pca code )

有关无刷电机的仿真程序，适合研究电机的人 (something about brushless dc motor)

求混沌时间序列K熵(Kolmogorov Entropy)STB算法(Seeking chaotic time series K entropy (Kolmogorov Entropy) STB algorithm)